Clearing Codes of Lippert Ground Control Auto Level System
Question:
I have a 2018 pinnacle. We get an error message for the rear leveler. The middle leveler does not come down. Is there a reset button
asked by: Nancy C
0
Expert Reply:
You can try manually clearing the error code of your Lippert leveling system by holding the retract and enter button simultaneously. Try that and hopefully the error message goes away and you'll regain use of middle jacks.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review