Picking Out New Hub/Drums for 1992 Deckliner Trailer
Question:
Hello. I have a 1992 VIP Deckliner trailer. My brake drum is cracked and the bearings, seals and races need replaced. Wheel bearing went out. Any way to find these parts with this much information? I couldnt get the numbers off the broken parts. If so, could I get the drum with bearings already installed? Thank you.
asked by: Barry K
Expert Reply:
We definitely can help you get new bearings, seal and hub for your 1992 Deckliner trailer but we don't have a way to look up the parts based solely on what you listed as the trailer manufacturers do not release that info and often times people replace axles anyway.
In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your wheels. I attached an FAQ article on determining bolt pattern for you to check out.
Next thing you will need to know is what spindle you have on your trailer. In order to do that you can either get the inner and outer bearing numbers from a hub or use a dial or digital caliper to get exact measurements of the spindle. The measurements needed are the parts of the spindle where the bearings ride.
If you get back to me with that information I will help you pick out the right hub assemblies. Or, you can follow the link I attached that will take you to the page that has all of our replacement hubs.
You would want to first select the bolt pattern that you have, next select the inner bearing you have, followed by selecting your outer bearing, and then all the correct hubs will be listed.
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Wheel Cylinder - 10" and 12" Single Serve LH
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- Wheel Cylinder
- 10 Inch
- 12 Inch
- Uni-Servo
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is Push Rod Included With Replacement Wheel Cylinder
- Q&A: How To Bleed Hydraulic Surge Brakes On Titan Model 60 Multi-Fit Brake Actuator
- Q&A: How to Determine Needed Pilot Diameter of Steel Dual Trailer Wheel
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Troubleshooting HydraStar Electric Over Hydraulic Actuator Not Building Pressure While Running
- Q&A: Electric Over Hydraulic Brakes Don't Work w/Brake Pedal on Newer GM Trucks w/OEM Brake Controller
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: 2023 Best Gifts for RVers & Campers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes