Determining Fit for a Trailer Landing Gear
Question:
I like these jacks. hwo do I knwo they'll fit my trailer?
asked by: Mike
0
Expert Reply:
You will need to measure the distance between the weld stops and brackets for # UF17-943010 to determine if these will fit your trailer. The weld stops and brackets need to line up with the dimensions of 14 1/2" or 20 1/4" from outside to outside for these to work. If these don't match then you will need to cut off the brackets and reweld in the correct locations. I have attached a diagram, review video, and the installation instructions as well to help you get started.
expert reply by:
Patrick R
0
![Patrick R](https://images.etrailer.com/static/images/catg/people/1811_tn.jpg)
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommendation for Replacing Bevel Gears for Atwood Landing Gear or Replacing Entire Landing Gear
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Tire Sizing