Are Load Resistors Needed for Reverse LED Trailer Lights
Question:
Before I tried to install LED brake lights and sense I didnt have a resistor installed when the truck was off a small amount of power was getting to the lights and leaving them dimly lit. Will I have this issue with reverse lights or since there shouldnt be much amperage going to them when the truck is off will the not be dimly lit?
asked by: Jared
Expert Reply:
You will not need load resistors to install the Optronics LED Backup Light for Truck or Trailer # BUL35CB; load resistors are not needed for reverse lights like these.
The only thing you will need are Grommet # A33GB and a 2-wire pigtail, either part # A45CB or the right-angle pigtail, part # A49PB.
I have added links for video reviews for you to check out as well.
Products Referenced in This Question
Grommet for ST33 Series Tall Rectangle Flush Mount Trailer Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 6-1/4 Inch Long
- Rectangle
- Optronics
more information >
2-Wire Pigtail for Optronics Backup and Utility Trailer Lights - 2-Prong PL-3 Plug
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Two Wire
- Straight Pigtail
- Optronics
more information >
Right Angle 2-Wire Pigtail for Optronics Backup and Utility Trailer Lights - 2-Prong PL-3 Plug
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
Product Page this Question was Asked From
Optronics LED Backup Light for Truck or Trailer - Submersible - 16 Diodes - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 5-5/16L x 3-7/16W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: Difference Between Dexter DX7.5L A-60 & A-60XL Disc Brake Actuator
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: Finding a Hub for a Very Old Trailer with 6 Lug Bolt Pattern # 1779 inner and # 2788 Outer Bearings
- Q&A: Replacemnet Surge Brake Actuator For a Tie Down Engineering LP7000
- Q&A: Cross Reference Chart for Kodiak Trailer Disk Brake Pads to Automotive Applications
- Article: Trailer Wiring Diagrams
- Article: 2023 Holiday Must Haves
- Q&A: Power Inlet Needed To Add Shore Power To An Enclosed Trailer
- Q&A: Replacement for UFP HD1377 Trailer Hub/Drum
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch