Can Rapid Hitch Adjustable Ball Mount be Used in Rise Position
Question:
I did have to drill the pin hole out a little to make it work in the up position. I will be looking for a winch and mounting plate for a 2007 Yamaha Wolverine 450 4x4.
asked by: Ramage G
0
Expert Reply:
Yes, you can use the Rapid Hitch Adjustable, Aluminum Ball Mount Kit # AM3410 that you referenced in the rise position.
expert reply by:
Jameson C
0
Products Referenced in This Question
Bulldog Winch Powersports Series ATV Winch - Wire Rope - Roller Fairlead - 2,000 lbs
- Electric Winch
- ATV - UTV Winch
- 1-Stage Planetary Gear
- 1.0 HP
- 1001 - 2000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- No Remote
- Wire Rope
- Bulldog Winch
more information >
Bulldog Winch Custom-Fit Steel ATV Winch Mount
- ATV Winch Mount
- ATV Winch Mount
- Bulldog Winch
more information >
Product Page this Question was Asked From
Rapid Hitch Adjustable, Aluminum Ball Mount Kit w/ 2 Zinc Balls - 5-1/2" Drop
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Aluminum Shank - Silver
- Drop - 5 Inch
- Rise - 6 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- Andersen
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Margay Wheel in Gunmetal Gray for ALCOM Stealth Car Hauler
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Tire Replacement for Size 8.55-15ST
- Q&A: Replacement Recommendation for TDE 46210 Hub
- Q&A: Removing Trailer Ball from Andersen Rapid Hitch Ball Mount
- Article: What To Look For When Buying Ratchet Straps
- Q&A: Fastway e2 Weight Distribution Recommendation for 2021 R-Pod 195
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: How To Use the Performance Tool Vehicle and Trailer Aligner with an Aluminium Ball Mount
- Article: Which Hitches are Made in the USA
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: Performance Chips and Modules
Ramage G.
7/22/2019
I did have to drill the pin hole out a little to make it work in the up position. I will be looking for a winch and mounting plate for a 2007 Yamaha Wolverine 450 4x4.