Troubleshooting Trailer Wiring Where Turn and Brake Signals Stop Working
Question:
plug in on truck no power for turn or brakes got no power to 7 or 4way check plug why no power check fuses all seem ok
asked by: Robert M
0
Expert Reply:
Most likely what you have going on are dirty pins on your trailer wiring connectors. This is almost always the issue when trailer lighting functions stop working. It can be on the ground circuit which affects all functions or on individual pins which then affects individual circuits. Take some sandpaper to the pins of the connectors and you should see them start to work again.
I also attached a help article on trailer lighting troubleshooting as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions of the Convert-A-Ball Cushioned Weight Distribution Shank # AMAC1
- Q&A: Distance from Pin Hole Center to End of Bar on Reese Weight Distribution Shank RP63971
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: Can 2021 GMC Sierra 1500 5-3/4 foot Carbon Pro Bed Install Fifth Wheel Rail Kit
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Towing a Trailer? Let's Talk About Brake Controllers