What are the Dimensions of the Jack Mounting Bracket for Fulton Marine Trailer Jacks
Question:
What are the dimensions of the Fulton Mounting Bracket #P9012-00? Will one fit well welded on a 2x2inch trailer tongue?
asked by: Steve
0
Expert Reply:
I went out to the warehouse and pulled a jack mounting bracket, # P9012-00, to take some measurements. The overall side to side length is 4-1/2 inches. Top to bottom it is 4-1/4 inches (see photo).
This bracket will weld to a 2 x 2 inch frame. The top lip gets welded to the top of the trailer frame. The two sides will get welded to the outboard side of the trailer frame. The bracket will overhang the bottom of the frame by a couple of inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Jack Mounting Bracket for Fulton Marine Jack - Weld-On
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Fulton
more information >
Continue Researching
- Q&A: Compatibility of Fulton F141132 XLT Trailer Jack With Weld-On Mount for Existing Jack
- Q&A: Recommended U-Bolts for Weekend Warrior LE-3305 Axle Flip Project
- Q&A: Replacement Trailer Jack for Shelby Model 5764A on Boat Trailer
- Q&A: Replacement Bolt-On Fulton Trailer Jack
- Q&A: Replacement for Shelby 5764A Trailer Jack on 2000 Four Winns Horizon 180
- Q&A: Replacement Trailer Jack for Viking Legend Pop-Up Camper
- Q&A: Handle Hits Boat Using Fulton XLT Bolt-Thru Swivel Trailer Jack F141132
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure a Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule