Will the Timbren Axle-Less Trailer Suspension Systems Work With An I-Beam Trailer Frame
Question:
How are the Timbren Axle-less suspensions I talked on an I-beam trailer?
asked by: Josh H
0
Expert Reply:
The Timbren Axle-Less Trailer Suspension System part # A35RS545E will work just fine on an i-beam trailer frame so long as you box in the side of the frame that the bracket for the system attaches to. This essentially means you will have to weld a steel plate on the i-beam frame where the bracket for the above system would install. If you are able to do this then you will have no issue with installation. This part of the process is also somewhat covered in the installation manual as well.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension w Electric Brakes - Standard Duty - No Drop - 5 on 4-1/2 - 3.5K
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- Electric Brakes
- 3500 lbs
- 5 on 4-1/2 Inch
- Universal Fit
- No Drop or Lift
- Timbren
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Q&A: Recommended 5 Lug Timbren Axle-Less System for 13" Trailer Tires
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacement Axle for 1968 Shasta Camper
- Q&A: 4-Way and 7-Way Trailer Wiring Harness For a 2023 Mazda CX-50 With Curt Trailer Hitch Receiver
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Lighting Requirements
- Q&A: Will Roof Rails Work On a Teardrop Trailer T@B
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Availability of 3500 lb Timbren Axle Less Kit with 4 inch Lift
- Q&A: How To Install The Advent Air RV Air Conditioner System With ACTH12 Thermostat
- Q&A: How to Upgrade Trailer with 45 MPH Speed Rating for Highway Speeds