Can CIPA Comp Rearview Boat Mirror CM01875 Attach to Angled Bracket that is Angled Back 20 Degrees
Question:
I measured the transom on my rowboat and it is under 1.25. If I mount the clamp on the transom, is there enough adjustment to allow the mirror to stand vertical? The transom is angled back from the vertical by about 20 degrees.
asked by: Phil P
0
Expert Reply:
Yes, there is enough adjustment in the CIPA Comp Rearview Boat Mirror # CM01875 that would allow the mirror to angle vertically if the transom angle of your setup is set back 20 degrees. I attached a picture that shows the two areas where this is adjustable which allows the adjustment you'd need.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
CIPA Comp Rearview Boat Mirror - Convex - Square Windshield Mount - 14" Long x 7" Wide
- Boat Mirrors
- Boat Mirrors
- Convex Mirror
- Clamp-On
- 14L x 7W Inch
- Black
- CIPA
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Weight Capacity of Stallion Aluminum Car Hauler Ramp Set # 288-07503
- Q&A: How To Measure For Correct Safety Chain Length For Trailer
- Q&A: Max Highway Speed Rating for 4.80-12 Tires
- Article: Determining Trailer Tongue Weight
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Solution for Surge Trailer Brakes that Activate When Backing Trailer Up
- Q&A: When Truck is Put in Reverse the Trailer Brakes Lock Up
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Boat Accessories
- Q&A: Recommended Boat Rearview Mirror for Frameless Windshield
- Q&A: Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted
- Article: 2023 Best Gifts for Boaters & Fishing Enthusiasts
- Article: My Trailer Hitch Doesn't Fit
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?