Dimensions of Square Opening for the Roadmaster Crossbar-Style Base Plate Kit # 1012-1
Question:
What is the diameter of the square receiver tubes for the baseplate arms? Are they 1 1/4 inch or 2 inch?
asked by: Bruce F
0
Expert Reply:
The receivers for the Roadmaster Crossbar-Style Base Plate Kit # 1012-1 are about 1-1/2" square.
Please note that base plate kits are only designed to be used for a flat towing application and accessories like a bike rack or cargo carrier should not be installed in them.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Hitch Pin Attachment
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Tow Bar Wiring For 1999 Chevrolet Tracker Being Flat-Towed Behind Motorhome
- Shop: Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Shop: Demco Classic Base Plate Kit - Fixed Arms
- Shop: Base Plate for Tow Bar
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Recommended Flat Towing Set Up for a 1998 Chevy Tracker
- Q&A: Parts Needed to Flat Tow a 2007 Chevy HHR Behind a Motor Home
- Q&A: Base Plate Kit Recommendation for Towing a 1995 Geo Tracker
- Q&A: Recommended Base Plate for a 2014 Honda CR-V
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Base Plate, Tow Bar and Accessories for Flat Towing 2000 Chevy Tracker
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Roadmaster # 1012-1 Base Plate Installation on 1999 Suzuki Vitara
- Article: How to Measure for Trailer Hitch Drop
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: What Is a Supplemental Braking System?
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide