Travel Trailer with Lippert Ground Control Won't Level Troubleshooting
Question:
What to do?Jayco 2020 36fbts will not level.
asked by: Debra L
Helpful Expert Reply:
Sounds like your Jayco 2020 36fbts has a Lippert Ground Control System part # LC358590 that needs a zero point calibration.
Here's how to do this:
The “Zero Point” is the programmed point that the trailer will return
to each time the Auto Level feature is used.
Note: Prior to starting this procedure, double check all connections
on the controller, jacks, and touch pad.
1. In manual mode, run the jacks to level the trailer. This is best
achieved by placing a level in the center of the trailer and leveling
it both front to back and then side to side. (See “Basic Jack
Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO
POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER”
button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is
complete.
8. The system will set this point as its level state and the touch pad
will turn off.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review