Torque Specs for Install Bolts of Bulldog Cast Head Coupler w/ Wedge Latch # BD4420000317
Question:
What are the tort full specs for this coupler?
asked by: Rudy R
0
Expert Reply:
The lock nuts of the Bulldog Cast Head Coupler w/ Wedge Latch # BD4420000317 need to be torqued down to 110 ft lbs of torque.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Cast Head Coupler w/ Wedge Latch - 2-5/16" Ball - Flat Plate Mount - 20,000 lbs
- Flat Mount Trailer Coupler
- Fixed Coupler
- Bolt-On
- Weld-On
- 20000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Trigger Latch
- Bulldog
more information >
Continue Researching
- Shop: Valterra Waste Valve for RV Gray Water Tank w/ Cap - 1-1/2" Diameter - Spigot to Male Thread
- Q&A: What are the Bolt Hole Sizes on the Bulldog Cast Head Coupler and Can it be Welded
- Q&A: Can the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box Be Used in a Short Bed Ram 3500
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Q&A: What Coupler Lock Fits the Demco Trailer Coupler # DM99VR?
- Q&A: Needing a Repair Kit for a Bulldog Trailer Coupler
- Article: How to Measure a Trailer Axle
- Q&A: Replacing Lippert 5,200 lb Axle with Dexter 5,200 lb Axle 86.5 Inches Hub Face to Hub Face
- Q&A: Replacement Leaf Springs for 1998 Coachmen Catalina 364 TBS
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Trailer Tire Sizing
- Article: Trailer Hitch Receiver Sizes