What is Minimum Slide Topper Clearance from Box Width and Awning
Question:
I have a 2018 Crusader 5th wheel my main slide is 129inch from flange to flange, but I only have 3inch of clearance on the side where my awning is. What topper could you recommend and if its shorter than would I move mounting in on each side
asked by: Joe G
0
Expert Reply:
We've checked with Solera before and they've said that 3 inches of clearance is the minimum needed for their Solera slide toppers to fit. So if you have 3 inches it would be tight but it would fit.
Based on your flange dimension being 129 inches the correct slide topper would then be the part # LCV000184673.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 133" Wide - Black
- RV Awnings
- Slide-Out Awnings
- Extends 48 Inches
- 128 Inch Wide
- 129 Inch Wide
- 130 Inch Wide
- 131 Inch Wide
- 132 Inch Wide
- 133 Inch Wide
- Black
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Correct Solera RV Slide-Out Awning Measurements
- Q&A: Which Solera Slide Topper Fits Slide Out Dimension of 133-5/8 inches
- Q&A: Recommended Slide Out Awning For A Slide Out With Limited Mounting Bracket Space
- Q&A: Replacement Control Board for HappiJac Jack System with Corded Controller
- Q&A: Replacing Wired Remote With Wireless Remote For Happijac Electric Jacks
- Q&A: Trailer Tow Package Turn Signal Fuse and Relay Locations on a 2010 Ford F-150
- Q&A: Can the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box Be Used in a Short Bed Ram 3500
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: How Much Solar Power Do I Need For My RV?
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Receiver Sizes
- Article: Best RV Roof Vents