Troubleshooting No Stop/Turn Signal Lights on Trailer But Running Lights are Active
Question:
Any ideas what it is No brake lights or turn signals on trailer but have running lights
asked by: Jennifer S
Expert Reply:
So the stop/turn circuits on a trailer typically draw the most amperage so if your trailer wiring had an insufficient ground this would be the time it would show up.
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2992 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30