Activating Brake Controller Wiring on 2000 GMC Yukon XL
Question:
I have only 2v on the green blk 12v terminal at the truck. All the rest are fine
asked by: Glen P
0
Expert Reply:
On your 2000 GMC Yukon XL 2500 there are a few connections you need to make under the hood to activate the brake controller wiring of the vehicle. If you check out the attached link on this page you'll see all the steps needed to activate all of it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Hitch Adapters and Extenders
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Recommended Wet Bolt and 2-1/4" Shackle Strap Kit for Tandem Axle Trailer
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: Replacement Dexter Grease Seal for Seal Part K71-386-00
- Article: Troubleshooting Brake Controller Installations
- Q&A: Trailer Hitch and 7-Way Wiring Harness for Freightliner M2