Is Welding Required to Install the Dexter Trailer Springs Over-Under Conversion Kit
Question:
Is welding required to put this kit on
asked by: Brandon
0
Expert Reply:
It is recommended that the spring pads be tack welded in place when installing the Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00 to avoid the axle slipping but aside from that there is no other welding. I have attached the installation instructions and a cutout showing this part of the instructions for you to check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler
- Q&A: Replacement Leaf Springs For a 2007 Feetwood Redline 33 Toy Hauler Travel Trailer
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit