How Do Aries Step Pads with Barrel Nuts Install on Step Bar
Question:
how to install nerf pads?
asked by: Robert M
0
Expert Reply:
The install is pretty simple actually. You put the included barrel nuts of the # AA2090133 in the step bar and then when you press the step pad in place the barrel nut grabs both the step pad and the step bar and holds everything together. If there are barrel nuts currently installed in the step bar you'll need to remove them. You may have to drill them out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Step Pad for Aries 4" Wide Oval Nerf Bars
- Accessories and Parts
- Nerf Bars - Running Boards
- Step Pad
- 4 Pegs
- With Clips
- Aries Automotive
more information >
Continue Researching
- Q&A: Replacement Pads For An Aries Automotive 4" Wide Oval Nerf Bars
- Q&A: Replacement Pads For 4 Inch Wide Nerf Bars With 24 Inch Step Pad
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Availability of Bully Nerd Bar Replacement Step Pads
- Q&A: How to Tell if Controlled Motion Hinge for RV Entry Door Will Fit 2005 Winnebago Vectra Motorhome
- Q&A: Recommended Replacement Entry Door Hinge For With A 6-Leaf Configuration
- Q&A: B&W Companion Draw Down Bolt Not Tightening to Installation Specs
- Q&A: Troubleshooting Difficulty Operating Slider on B&W Companion Slider 5th Wheel Hitch
- Article: Brake Controller Installation: Starting from Scratch