Will the Curt Multipurpose Ball Mount, # D210 Fit on a 2012 Toyota Sienna SE

Question:

Will this unit clear the bumper on a 2012 Sienna SE?

asked by: Christian

Expert Reply:

To determine if the Curt Multipurpose Ball Mount, # D210, will work in the 2 inch receiver hitch on your 2012 Toyota Sienna SE, you will need to measure from the center of the hitch pin hole on your trailer hitch to the farthest back part of the rear bumper fascia. Standing a yard stick up at the back of the vehicle touching the rear fascia and measuring to the center of the hitch pin hole is an easy way to get this measurement.

The # D210 ball mount measures 5-1/2 inches from the center of the hitch pin hole to the closest part of the upper receiver.

We did a trailer hitch installation on a 2011 Sienna, see attached photo, and the trailer hitch measured 5-1/4 inches from the center of the hitch pin hole to the farthest back part of the bumper. This means that if you come up with the same measurement, the # D210 should fit but it is going to be very close and you should measure carefully to be sure.

expert reply by: Robert G