Does Pressure Need to be Off of Landing Gear Jack When Installing Repair Kit # LG-146059
Question:
Hello, I purchased this kit and need to install it as my shaft broke. Do i need to have the trailer on the truck or is it something that can be done while pressure is on the legs? Thanks so much,
asked by: Mike G
0
Expert Reply:
You will need to take pressure off of your landing gear legs to install the Repair Kit # LG-146059 because you will be messing with the gears that are used to operate the jack.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement gears for Lippert Landing Gear Instructions and Diagram
- Article: Trailer Tire Sizing
- Article: How to Measure for Motorhome Steps
- Q&A: Venture Bevel Gear Kit Instructions
- Q&A: Landing Gear Repair Kit for Venure VMC900L Follow Leg
- Q&A: Replacement Landing Gear Legs for Set with Number VMC900R
- Q&A: Useable Length Of Replacement Rail Pins For 5th Wheel Trailer Hitch
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)