Does Jack Need to be Removed or Pressure Taken Off of Jack to Install the Repair Kit # LG-146059
Question:
Do I need to remove jack, jack leg, or take pressure off jack/camper to install this kit?
asked by: Dane C
0
Expert Reply:
You definitely need to at least take pressure off of the jack leg to install the Repair Kit # LG-146059. If you have enough room to operate then you might be able to install the repair kit without removing the jack but it would be much easier with the jack removed from your camper plus if you dropped something inside the jack you would be able to quickly retrieve it.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Diagram to Use when Installing Lead Jack Repair Kit # LG-146059
- Q&A: Replacement Leg for Lippert Ground Control 2.0 LC241846
- Q&A: Landing Gear Repair Kit Recommendation for a VMC900R Set
- Q&A: Replacement Option For Atwood OD-5001 Water Heater
- Q&A: Do the Roadmaster Mud Flaps Connect to the Hitch Receiver or to the Ball Mount?
- Q&A: Recommened Removable Mud Flap System for a 2-1/2" Hitch Receiver
- Q&A: Lippert Components Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear Install Diagram
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How Much Solar Power Do I Need For My RV?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)