Mounting Hole Spacing of Trailer License Plate Light with Housing # LP81BB
Question:
Want to use on 2015 equipment trailet
asked by: Paul I
0
Expert Reply:
The mounting hole spacing of the Trailer License Plate Light with Housing # LP81BB that you referenced is 3-7/16 inches.
I attached a review video for this for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer License Plate Light with Housing and Mounting Bracket - Clear Lens - Black Base
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-9/16W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement Drop Leg for a Bulldog Tongue Jack
- Q&A: Bearing/Race/Seal Kit for Boat Trailer w/ NOK AD7131E Seal 25580 Inner and LM67048 Outer Bearing
- Article: Snow Tire Chains Explained: How Tire Chains Work & When to Use Them
- Q&A: Replacement Antenna for Voyager WVCMS130AP Back Up Camera on Airstream International Serenity RV
- Q&A: Can Dual Wheels On 10K Dexter Axles Be Changed Over To Super Single 17.5" Wheels and Tires?
- Q&A: Does It Matter Which Wire is Power and Which is Ground When Wiring Electric Brakes
- Q&A: How to Convert Oil Bath Trailer Hubs to Grease Hubs
- Q&A: Can Red Identification Light Bar be Used as Marker & Reverse Lights
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide