Bolt Pattern of Mounting Flange of Hydraulic Brake Kit # AKFBBRK-35-D
Question:
What are the measurements on center of the four mounting studs?
asked by: Jeremy
1
Helpful Expert Reply:
The distance between the 4 mounting studs of the Hydraulic Brake Kit # AKFBBRK-35-D that you referenced is 2-7/8 inches vertically and horizontally. This is the standard 4 bolt pattern for trailer brake assemblies.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 10" - Left/Right Hand - 3,500 lbs
- Trailer Brakes
- Hydraulic Drum Brakes
- Marine Grade
- Free Backing
- Manual Adjust
- Single Servo
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: What Size Hardware Should Be Used With the Super Titan Forged Pintle Hook Plate
- Q&A: Will the Pintle Hook # 63015 Attach to the Super Titan Pintle Hook Plate # RP38186
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: Best Ladder Racks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)