Will CIPA PWC Mirrors # CM11120 Fit 1994 Seadoo GTX
Question:
I have a 1994 Seadoo GTX. It came with mirrors. Will this fit into the factory holes or do I still have to drill?
asked by: Glenn H
0
Expert Reply:
That's harder to say since the CIPA mirrors part # CM11120 that you referenced are a universal mirror that has not been tested on your specific PWC. Best option would be to take off the mirrors currently and determine the diameter of the holes now. The hole size needs to be 1/4 inch in diameter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CIPA Sport Side Mirror for PWC - 3-1/2" Tall x 5-3/8" Wide - Rectangular - Black
- Boat Mirrors
- Personal Watercraft Mirrors
- Flat Mirror
- Bolt-On
- 5-3/8L x 3-1/2W Inch
- Black
- CIPA
more information >
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Q&A: Replacement Grease Seal and Bearings for 1992 Mastercraft Boat Trailer
- Q&A: Recommended etrailer Coupler Lock for Rolled Lip Coupler
- Q&A: How Does the Titan BrakeRite EHB Electric-Hydraulic Actuator Wire Up
- Q&A: Replacement Brakes and Bearings for 1993 Mastercraft Boat Trailer
- Q&A: What is the Diameter of the Handle on the Manual Override Crank for Bulldog 500203
- Q&A: 5th Wheel Hitch Recommendation for 2021 Ram 2500 Short Bed - B&W Companion Hitch w/ Slider
- Article: Where to Position the Trailer Axle?
- Q&A: How Much Weight Can Landing Gear Hold