A-Frame Trailer Jacks that Have Highest Lift Ability
Question:
I have a 1972 Prowler trailer. We have moved the axle to under the springs to give the black water and gray water tanks more clearance on the trails and hills of course the axle still clears the same. This has improved the entry and departure angle for all underslung items like bumper and sewer . Weve slowly improved all the cascading results of this change like adjusting the leveling hitch and ball height, a fold out grab bar for entry stairs, an extra step on a the fold out stairs, and a new side winder tongue jack with better gears and lift. However, if there is any down slope towards the front of the trailer we quickly max out the lift on the current tongue jack even with a tall foot. What is that tallest lift or longest travel 3 bolt tongue jack I can obtain for this trailer? Wed prefer hand crank, but it seems the electric ones have more lift range. After scouring site, I feel I am not finding what I need. Any advice would help.
asked by: Joe
Expert Reply:
The powered A-frame trailer jack we offer that has the highest possible lift is the Phoenix Trailer Jack part # UF38-944055 which can lift up to 21 inches and has an extension foot for an additional 5 inches. This puts it at a total of 26 inches.
Then the manual crank jack we offer that has the highest possible lift would then be the Ultimate Trailer Jack part # 322-RDJ-2K which can be configured to give up to 27-1/2 inches of lift.
Products Referenced in This Question
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Product Page this Question was Asked From
Phoenix Electric Trailer Jack with Remote - A-Frame - 26" Lift - 5,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 26 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White
- Shop: Dutton-Lainson Boat Trailer Tongue Jack - Bolt On - Sidewind - 30" Lift - 2,000 lbs
- Video: Review of Dutton-Lainson Trailer Jack - Boat Trailer Jack - Side Frame Mount Jack - DL97MR
- Video: Rampage Vehicle Heaters - Interior Vehicle Heater - RA3501 Review
- Shop: Vehicle Engine Heaters
- Shop: Replacement Vent Cover for Valterra RV Battery Box Vent - 1-3/4" Hose Opening - Black
- Shop: Rampage Radiant Backseat Heater - 300 Watt - 12 Volt
- Shop: Phoenix Electric Trailer Jack with Remote - A-Frame - 26" Lift - 5,500 lbs
- Q&A: How To Stop A-Frame Jack From Scrapping Ground While Going Over Bumps
- Search Results: jack wheel
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Q&A: Load Resistor For Correcting LED Trailer Running Lights That Light Dim When Vehicle Is Turned Off
- Shop: Trailer Wiring
- Q&A: Installing LED Light Bulb Load Resistor Kit
- Article: Trailer Wiring Diagrams
- Q&A: Will Load Resistors Prevent LED Trailer Taillights from Dimly Lighting Up when Vehicle is Off
- Q&A: Which Wires Are Used When Installing Marker Lights On Trailer
- Video: Optronics Trailer Lights - Clearance Lights - MCL13A2B Review
- Video: Dutton-Lainson Drop Leg Trailer Jack with Footplate Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL66AB Review
- Video: Review of Peterson Trailer Lights - Reflectors - 465-4K
- Video: Optronics Mini LED Side Marker Light Installation
- Search Results: footplate
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Troubleshooting Trailer LED Lighting that Partially Illuminates When Connected to Tow Vehicle
- Search Results: sway bar