Could Trailer be Drilled to Allow Install of B&W Extend-A-Goose Gooseneck Coupler # BWTEXA4200
Question:
just picked up a vintage car trailer, installed the bandw noticed there cross holes even offset dont match with mine, still a a bit cocked, do i drill a new hole in my tube?
asked by: Keith P
0
Expert Reply:
Normally drilling is not required when installing the B&W Extend-A-Goose Gooseneck Coupler # BWTEXA4200. Typically this has the correct hole size and location for most trailer applications. But if you need to drill your trailer to give you the correct matching hole size for this you certainly could.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
B&W Extend-A-Goose Gooseneck Coupler - 2-5/16" Ball - 10" Offset - 24,000 lbs
- Gooseneck Coupler
- Coupler with Inner Tube Only
- Round Tube
- 6000 lbs TW
- 24000 lbs GTW
- 2-5/16 Inch Gooseneck Ball
- Manual Latch
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation of B&W Extend-A-Goose Gooseneck Coupler
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: Dimensions of the B&W Extend-A-Goose Gooseneck Coupler From the Bend in Upright to Bottom
- Q&A: B&W Companion for 1/2 Ton 2022 Ford F-150 Short Bed
- Q&A: What Is The Function Of The Draw-Down Bolt On B&W Companion Fifth Wheel Hitch
- Q&A: Would Moving Companion Hitch Head Forward or Back Help with Bed Rail Clearance
- Q&A: Does Using an Offset Gooseneck Ball Change where the Pin Weight is Carried in the Truck Bed
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose a Battery Charger