Hole Dimensions of Snap Ring Bracket for Fulton Snap Ring Swivel Jack Part # FTJ12000101
Question:
Looking for replacement jack for my 92 Mastercraft trailer. Current jack is a snap ring attachment just like this jack and welded to frame if I recall. I would prefer not to have to remove the current attachment and just replace the jack by removing the snap ring and replacing. What is the size of the circular opening where the jack attaches and the snapring goes? What is the distance from center to the center of the holes for the pin for swiveling? Thank you, just want to make sure this jack will work before purchasing.
asked by: Matthew S
Expert Reply:
The hole in the bracket of the Fulton 1200 lb Snap Ring Swivel Jack is 2.55 inches in diameter to accommodate the 2-1/2 inch diameter flange on the trailer mounted bracket that the snap ring attaches to. The 2-1/2 inch diameter flange on the trailer bracket passes through the 2.55 inch diameter hole in the bracket on the jack.
The holes that the retaining swivel pin passes through are 3 inches apart on center.
I have produced a photo of the snap ring bracket included with the above mentioned jack, complete with dimensions. In order for the bracket that is existing on your trailer to work with this jack, the dimensions will need to be identical.
![Mike L](https://images.etrailer.com/static/images/catg/people/166_tn.jpg)
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Hub with LM67048 Inner Bearing and LM11949 Outer Bearing
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
- Q&A: What is the Angle of the CE Smith Roller-Style Guide-Ons for Boat Trailers
- Article: Where to Position the Trailer Axle?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Jacks