Are Washers Always Needed Between Spindle Nut and Outer Bearing
Question:
no washer needed on the outer bearing before the nut-between the nut and the outer bearing?
asked by: Ed H
1
Helpful Expert Reply:
Spindle washers aren't always used. We actually sell complete axles with hubs like the # 20440I-ST-72 which does not come with washers. Typically if a washer is needed it will be on a higher capacity hub/axle.
expert reply by:
Jameson C
1
Products Referenced in This Question
Dexter Trailer Axle with Idler Hubs - 4 on 4 Bolt Pattern - 72" Long - 2,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Spindles
- Idler Hubs
- 2000 lbs
- 4 on 4 Inch
- 58 Inch Long
- 72 Inch Long
- No Drop or Lift
- Dexter
more information >
Product Page this Question was Asked From
Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- 2500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Article: How to Raise Your Travel Trailer Height
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Recommended Replacement AC Unit For A Coleman Mach On A 2000 Mesa Pop Up Camper
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Article: Pintle-Hitches
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Q&A: Replacement Bearings and Hub for Malone MicroSport Trailer
- Q&A: etrailer Hitch that Fits 2021 Ram 1500 Classic