Troubleshooting Right/Stop Turn Circuit Not Active on New Trailer Wiring
Question:
I have no power to the right side turn signal and brakes on the trailer. All new wiring
asked by: Justin C
0
Expert Reply:
Have you verified that the tow vehicle has this circuit active on the 7-way with a tester like the part # PTW2993? This would be the pin in the 3:00 position. If you have voltage there but not on the trailer you'd want to go over the wiring of that circuit looking for any obvious signs of shorts and fix as needed.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30