Can Brophy D-Ring Tie Down Anchor Install Through Two Boards Next to Each Other
Question:
My trailer has 5/4x6 deck boards - would it be okay to split the hole in between them so the d ring and backing plate mounts with two bolts in each board? It seems stronger than drilling a 3.5” hole in the middle of a 5/4 board to me but I just wanted an expert opinion before I start drilling. Thanks!!
asked by: Kyle
0
Expert Reply:
You could install the Brophy D-Ring Tie Down Anchor # RR5K the way you described if you like. You could put two bolts through two boards right next to each other if you like.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1600 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Continue Researching
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Q&A: Can I Charge My Trailer Battery Using 7-Way Trailer Connector on Truck
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: What is Max Safe Tire Temperature
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Q&A: What are the Wire Colors and Functions of the Nissan Factory Brake Controller Harness
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Tire Sizing
- Article: Overview of Lubricating Grease
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Anti-Rattle Devices
- Article: How to Choose the Right Trailer Hitch Class