Hardware Typically Used to Install A-Frame Trailer Jack
Question:
Looking for size and thread of bolts needed to install a A-frame trailer jack.
asked by: Lonnie F
1
Helpful Expert Reply:
You can use three 3/8-16 grade 5 bolts to install the etrailer jack # TJA-5000S-B or any other style A-frame jack; though we do not carry the hardware it is available at any hardware store. I attached an install video for this jack for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Brake Controller
- Shop: 6-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 26" Long
- Shop: Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Shop: Equalizer for 2" Wide Slipper Springs - 13-1/8" Long - 7/8" Center Hole
- Shop: Camco RV and Enclosed Trailer Roof Vent Cover w/ Detachable Louvered Screen - White
- Shop: Fifth Wheel Hitch
- Search Results: 5~23
- Shop: D Washer for EZ Lube Spindles
- Q&A: Size of Bolt Needed for A-Frame Jacks
- Shop: Gooseneck Hitch
- Search Results: 23~434
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Reese Quick-Install Custom Outboard Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches
- Search Results: brw77fr
- Search Results: tjd~12000~hd
- Search Results: treq1344
- Search Results: e94sr
- Search Results: 337b03822sc
- Shop: Trailer Wiring
- Shop: Floor Mats
- Q&A: Replacement Titan Master Cylinder that is Stamped 23744
- Shop: Cabin Air Filter
- Q&A: Availability of Replacement Grease Seal with 1.938 Inner Diameter and 2.523 Outer Diameter
- Q&A: Required Bolt Length for Installing A-Frame Trailer Jack
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Leaf Spring for Trailer with Dexter 4,400 lb Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
James H.
7/1/2020
I have a 16' buck dandy trailer. Do I need to mount on top of trailer tongue , or the bottom ? Does it matter ? Bulldog 5000# trailer jack with triangle mount. I already have threaded holes on trailer. Appreciate any help. Thank You !