Selecting Transmission Fluid Temperature Gauge from Display of Edge CS2 Programmer
Question:
I can figure out how to put the transmission temperature gauge on edge 83530 is there any way that you could help?
asked by: Garrett
Helpful Expert Reply:
Here are the instructions for selecting a new PID like transmission fluid temperature with the Edge CS2 # EP85350 that you referenced.
Step 1: While viewing a gauge layout screen, press the Enter button. A gauge location will be highlighted.
Step 2: Use the arrow buttons to highlight the gauge location that you would like to modify.
Step 3: Highlight the Select New PID option. Then press Enter.
Step 4: Use the Up/Down arrow buttons to highlight a new PID, then press Enter.
Step 5: Select each of the remaining options to further customize your gauge.
Step 6: Return to the main gauge screen. The new PID will be displayed.
Product Page this Question was Asked From
Edge Gas Evolution CS2 Performance Tuner- Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Thule Hullavator Pro TH898 - What Are The 35mm and 37mm Bolts For?
- Article: Replacement Automotive Lighting
- Q&A: Will the Edge CTSV2 Work with my 2008 GMC Sierra 2500 with the 6.0L Gas Engine
- Article: Trailer Tire Sizing
- Article: Performance Chips and Modules
- Q&A: After Returning 2008 Chevy Silverado 4.8 to Stock w/Edge Programmer Will the Truck Run Any Different
- Q&A: How Close Should Thule Hullavator Pro Kayak Carrier Be
- Q&A: What Can the Edge Evolution Programmer Do on a 2008 Chevy Silverado 1500 5.3L
- Q&A: How To Use Rope With The Tie-Down Cleat for TracRac Ladder Racks
- Q&A: Trailer Hitch Recommendation for 2022 Subaru Forester Wilderness Edition
- Article: RV Cell Boosters, How Do They Work?
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)