Adapter Needed to Power Taillights of Camper that Have Separate Turn Signals and Brake Circuits
Question:
How do I connect Nissan 3500 passenger van tow vehicle with a seven pin circular 2 wire stop and turn wired to one lamp to a newly installed LED based 3 wire system in my camper? The camper now has separate turn and stop leads where as before it had one lead for the turn/stop lamp. Thanks.
asked by: DRCHAMP
Expert Reply:
Since your tow vehicle uses combined trailer wiring you'll need to install a signal converter on the camper so that you can get the stop/turn circuits separated out like you need. For that you'd want the part # 118158 and you'd be set. You'd want to install this on the camper's wiring since it is the factor in the equation that uses a non-standard setup.
Product Page this Question was Asked From
Vehicle to Vehicle Tail Light Converter
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- 7 Round
- Tow Ready
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Tow Bar Wiring Overview
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Q&A: Separating Out a Combined Brake Light and Turn Signal to Have Separate Turn Signals and Brake Lights
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Q&A: Grease to Oil Bath Trailer Hub Conversion Kit for 3500 Pound Axles
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Separating Trailer Turn Signals and Brake Lights
- Q&A: Do I Need a Charge Line to Flat Tow a 2022 Ram 1500?
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity