Distance From Mounting Surface to Pin Hole Center of Roadmaster Adapter Part # RM-033
Question:
I am looking at possibly using this adaptor to make a custom connection on a vehicle to use with my Demco Excalbar2 tow bar. Do you know what the measurement is from the back mounting surface to the center of the 5/8inch connection hole on the two tabs is? I am trying to see if the two tabs stick out from the mounting surface enough to clear an obstruction. Thanks,
asked by: Tad
0
Expert Reply:
I checked with Roadmaster and the distance from the mounting surface to the pin hole center on the Roadmaster adapter part # RM-033 is 3-1/4 inches.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Adapter for Blue Ox and Demco Tow Bars
- Accessories and Parts
- Base Plates
- Tow Bar
- Adapters
- Blue Ox to Roadmaster
- Demco to Roadmaster
- Roadmaster
more information >
Continue Researching
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Parts Needed to Flat Tow 2016 Toyota 4Runner
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Complete Flat Tow Parts For 2024 Chevy Silverado 1500 4x4
- Q&A: Rebuild or Repair Kit Availability for Blue Ox Aventa LX BX7445
- Article: Base Plate Adapter Table
- Q&A: Parts Needed to Flat Tow a 2008 Honda Fit Behind a Motor Home
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Replacement Ladder for 2018 Thor Challenger 37 FH with Indent on Rear
- Q&A: How To Flat-Tow a Chevrolet HHR SS
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Q&A: Parts Needed to Flat Tow a 2012 Scion xB Behind and RV
- Article: Must-Have Flat Towing Components
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)