What Causes Light Activation Delay on RV
Question:
The inside light doesn’t come on right away. Delays Wonder if I have the wrong bulb
asked by: Joe G
0
Expert Reply:
Typically light activation delay is due to a bad switch or a loose connection in the wiring of the light circuit. It's not usually related to the wrong bulb being used. I'd first check the condition of the switch looking for any corrosion and then check the wiring.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Shop: Curt RV Bumper 2" Trailer Hitch Receiver
- Q&A: What Could Cause Sparking When Connecting Brake Controller Directly to Battery
- Q&A: Troubleshooting Sparks on Safety Chains When Connecting to Hitch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Q&A: Troubleshooting Dexter Brake Actuator
- Q&A: All Parts Needed To Flat Tow 2019 Ford Expedition
- Q&A: Changing the Bulb in the Wesbar Tail Light Capsule
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Bathroom Interior Light for 2018 Trail Runner Camper
- Q&A: Should I replace My Castle Rock ST ST205/75R14 Tires
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Boat Trailer Guides: Which are the Best?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Lighting Requirements