Can the Spring Seats Be Moved on the Dexter 3,500 LB Drop Axle
Question:
Can I get this axle with a spring center to center of 70.5? What is the overall length?
asked by: Robert
Expert Reply:
The Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles part # 8327812 measures 89" long between each hub face and 74" long between each spring center. It is not offered with 89" between each hub face and 70-1/2" long between each spring center because the spring seats can be moved. The spring seats for this axle can be moved to a minimum of 75" apart and a maximum of 71" apart. Since you only need to go in 1/4" more on either side I would say you are fine to move the spring seats on this axle to sit 70-1/2" apart. In order to do this you will need to cut off the spring seats that come with the axle and then tack weld part # TRSS238 on.
The overall length of the Dexter Trailer Axle Beam is 93" from end to end.
Products Referenced in This Question
Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter
- Trailer Leaf Spring Suspension
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 2-3/8 Inch
- TruRyde
more information >
Product Page this Question was Asked From
Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Easy Lube Spindles
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Long
- 89 Inch Long
- Drop - 4 Inch
- Dexter
more information >
Continue Researching
- Search Results: 48 x 12 trailer tires
- Search Results: aps4
- Search Results: advent air conditioner
- Search Results: trailer drop axle
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 1-1/4" Rear
- Shop: Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 89" Long - 3,500 lbs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Search Results: k71~359~00
- Search Results: e47sr
- Search Results: dexter 8 247
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: 4-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/8" Long
- Shop: Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts
- Q&A: Recommended Double-Eye Suspension System for 2,000 lb Single Axle Boat Trailer
- Q&A: Replacement Leaf Springs for a Vintage Camper
- Shop: Loadstar 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range C
- Q&A: Where are the Leaf Spring Seats Located on the Dexter Trailer Axle Beam w/ Idler Hubs # 8327812-I
- Q&A: Diagnosing Overload Warning, No Brakes, On a Tekonsha Prodigy P3 Brake Controller
- Q&A: Do Trailer Axle Spring Seats Weld to Axles
- Q&A: Difference In Hub And Drum Product Quality
- Q&A: Does Trailer Hub and Drum Assembly # AKHD-5475-35-K Replace Dexter 3,500 lb Hub
- Video: Review of Dexter Axle Trailer Axles Parts - Torflex Axle Installation Hardware Kit - DX54FR
- Video: Redline Trailer Suspension - Leaf Spring Suspension - 29-31 Review
- Video: Redline Trailer Suspension - Leaf Spring Suspension - H248 Review