Usable Length of Trailer Suspension Wet Bolt # 126A1
Question:
THE 126A1 is listed as 3 1/2inch long. Is that the 3/4inch length or does it include the hex head of the bolt as well. If so, I need a 3/4inch x 4inch including head with a zerk. Do you carry such a bolt?
asked by: Gary
1
Helpful Expert Reply:
The length figure for the wet bolt part # 126A1 is measured from the below the head to end of the threaded section. So that does not include the hex head. I'd recommend measuring the usable length you need from your bolt. Most likely this will work for you though as this is a very common size for trailer suspension.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Wet Equalizer Bolt with Castle Nut, Grease Zerk and Cotter Pin - 3-1/2" Long
- Trailer Suspension Parts
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 3/4 Inch Diameter
- 3-1/2 Inch Long
- Redline
more information >
Continue Researching
- Q&A: Wet Shackle Bolts to Reduce Noise from Tandem Axle Travel Trailer Suspension
- Q&A: Replacement Trailer Clearance Light for PM150
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Do the Colors of Trailer Brake Magnets Mean Anything
- Q&A: Checking Electric Trailer Brake Magnets for Wear, Shorts, Amperage, and Resistance
- Q&A: What Colors are Trailer Brake Magnets Wires
- Q&A: Why Would New Trailer Brakes Feel Weak After Axle Replace
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 2023 Best Gifts for RVers & Campers