Location of Frame Mounted Bar to Base on B&W Biker Bar Motorcycle Tie-Down System
Question:
When the bar is locked fully into the clamp, is the bar located directly above the 5/8inch mounting bolts that bolt the clamp to the floor?
asked by: Darren R
0
Expert Reply:
The B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring # BWMC2301 does have the frame bar that almost directly sits over the mounting bolt in the floor bracket. As you can see in the video the locking of that bar can be to the front, up, or the back of your bike so that it doesn't interfere with the base.
Check out the attached photos and videos and let me know if you have further questions.
expert reply by:
Jason S
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Comparing Rota-Flex and Gen-Y 5th Wheel Pin Boxes
- Q&A: Prep-Work for Installing Small Coin Pattern Vinyl Flooring with Adhesive
- Q&A: What Is the Difference Between Biker Bar # BWMC2302B and # BWMC2301B?
- Q&A: Is There an E-Track Adapter for the B&W Biker Bar
- Q&A: Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
- Q&A: Will Using the B&W Biker Bar Put Too Much Stress on the Frame of a Touring Harley
- Q&A: Replacement Bearaing Kit For A 2013 Ranger Tandem Axle Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Tie Down a Motorcycle
- Article: Pintle-Hitches