Can the Motor and Fan Blade be Removed from Inside the Ventline Vanair Trailer Roof Vent VP-543SP
Question:
Can I access the fan components from inside the camper?? For example can I undo the internal flange and screen and then from the fan and motor out of the unit? If so, what are the attachment points? Thank you.
asked by: Rich
Expert Reply:
In regards to the Ventline Vanair Trailer Roof Vent part # VP-543SP, you can access the screen and switch from the inside but in order to access the fan blade and motor you would need be outside of the trailer. There are two screws that hold the top cover on. Once you remove these you can then pull the fan blade off the output shaft which will then reveal two more screws to remove the motor.
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 2-3/8 Inch
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Continue Researching
- Article: Replacement Automotive Lighting
- Q&A: Availability of Brake Line Fitting to go from 1/8 inch Male NPT to 3/16 Female FIF
- Q&A: Recommended Replacement Roof Vent For An Airstream Flying Cloud 23D Travel Trailer
- Q&A: Replacement Operator Mechanism for MaxxAir MaxxFan 4751KS
- Q&A: How To Install MaxxFan Dome Roof Vent On Thin Metal Roof
- Q&A: Availability of Dexter Leaf Spring 072-079-00 for 8,000 lb Trailer Axle
- Q&A: Circuit Board Replacement for MaxxFan 4751KS
- Q&A: How to Find Which Replacement Vent Lid Replaces Cracked Vent Lid on 1987 Lynx Prowler Camper
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Raise Your Travel Trailer Height
- Article: What are the Common Types of Propane Fittings Used on RVs?