What is the Distance From the Center of the Hitch Pin Hole to the Weld of the Platform, # C45009
Question:
What is the distance between the center of the hole that is in the 1 1\4inch tube and the weld that connects the fork?
asked by: Tom
0
Expert Reply:
On the CURT 2 Inch Ball and Clevis Bar Ball Mount, # C45009, the distance from the center of the hitch pin hole to the weld where the fork is attached is approximately 3-1/2 inches. It may very between mounts because the weld may be larger or smaller between units.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Ball Mount for 2" ATV Hitches - 2" Ball and Clevis Bar - 1/4" Rise
- ATV Hitch
- Ball Mount Only
- 2 Inch Ball
- CURT
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Best Way to Tow a Trailer and Attach a Bike Rack to the Same Hitch
- Q&A: Best Ram 3500 Truck Options to Pick for Gooseneck Trailer Towing
- Article: How to Raise Your Travel Trailer Height
- Q&A: Parts Needed to Install a 7-way on a 2022 Subaru Outback Wagon
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Cable Options for Trailer Ramp Door Spring
- Article: What Do I Need To Tow A Trailer?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch to Fit a 2019 Mazda 3 Sedan
- Q&A: Recommended Removable Wheel for Trailer Valet JXS Trailer Jacks
- Q&A: Bolt Pattern for Demco Hydraulic Brake Actuator DM72VR