Should Adhesive Backing of ThermaHeat RV Holding Tank or Step Heater Pad Be Left On
Question:
I need to slide the heater pad under an existing installed tank with only about 3/8inch gap. Would I be able to leave the backing on the adhesive side and leave it installed that way?
asked by: Scott G
0
Expert Reply:
You'll want to remove the adhesive backing of the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000163 before you leave it underneath a tank permanently. It probably wouldn't be a big deal in the short term but long term it's hard to say what the backing will do.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide
- RV Fresh Water
- Winterization
- Holding Tank Heating Pad
- LaSalle Bristol
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can ThermaHeat RV Holding Tank Heater Run to Inverter Instead of Battery
- Q&A: Difference Between the Blue Ox Alpha and Avail Tow Bars
- Q&A: Troubleshooting the Switch for Camco Propane to Electricity Converter Not Staying On
- Q&A: Do RV Gray and Black Water Tanks Require Heaters
- Q&A: Can Roadmaster Dual Hitch Adapter RM-077-4 be Used with Flat Towing Setup
- Q&A: Weight Distribution for a 2019 Jeep Cherokee Trailhawk and 2017 Palomini 177BH Travel Trailer
- Q&A: Difference in Blue Ox Acclaim vs. Alpha Tow Bars
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)