How does the Pro Series Square Jack with Footplate, # PS1400800383 Weld to a Trailer
Question:
I have a 16 ft. bumper pull stock trailer with the stock jack that has all the gears stripped. Assuming the old jack would be cut off, how exactly would this jack be welded on in its place?
asked by: Bruce H
0
Expert Reply:
The Pro Series Square Jack with Footplate, # PS1400800383, is a direct-weld jack meaning that you would weld the outer tube of the jack directly to the trailer frame. Welding should be done by a qualified professional welder. It would be best to determine where on the jack the welding will be and remove the powdercoating ahead of time to get the best weld.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pro Series Square Jack with Footplate - Drop Leg - Topwind - 28-5/8" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Topwind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Overall Width and Diameter of a 235/80R16 Size Tire
- Q&A: How to Hardwire a 12 Volt Accessory Outlet in a Truck Bed
- Q&A: Replacement Trailer Hub and Drum and Brakes for AL-KO 8490 Axle
- Q&A: What Size Pins are Needed to Install 5th Wheel Trailer Hitch to Husky Rails
- Q&A: Solution for Replacement Inner Tube on Pro Series Square Jack with Footplate
- Article: How to Measure for Trailer Hitch Drop
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Replacement For A Furrion FWHO9A-AM Tankless RV Water Heater
- Q&A: Difference Between Model Numbers Of The Furrion Tankless Water Heater
- Article: Trailer Jacks
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Measuring a Trailer Tire
- Article: Printable Trailer Bolt Hole Pattern Template