LED Compatible Combined to Separate Turn Signal Converter Box
Question:
Im adding 3 tail lights to the rear center of a 2015 freightliner. In this vehicle the brake and turn signal are in the same wire. i want the three tail lights that Im adding to come on only when i apply the brakes. The existing and new lights are LED. The notes under product #118158 stated not led compatible. wondering what i could use to make this work. Thanks
asked by: John
0
Expert Reply:
The Curt 2 to 3 converter part # 118158 is compatible with LED lights like what you have so it would work well for you. If you wire it to your current combined wiring you'll have separate tail light wiring like you want.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Vehicle to Vehicle Tail Light Converter
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- 7 Round
- Tow Ready
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Tow Bar Wiring Overview
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Q&A: Separating Out a Combined Brake Light and Turn Signal to Have Separate Turn Signals and Brake Lights
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Q&A: Grease to Oil Bath Trailer Hub Conversion Kit for 3500 Pound Axles
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Separating Trailer Turn Signals and Brake Lights
- Q&A: Do I Need a Charge Line to Flat Tow a 2022 Ram 1500?
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity