Distance from Bottom Adjustment Hole to Bottom of Footplate on etraileer.com Replacement Drop Leg
Question:
Hi, I was hoping you could tell me the distance from the lowest hole center to the bottom face of the assembly where the stand sits on the ground? Thanks!
asked by: Alex
1
Helpful Expert Reply:
I went out to the warehouse and found that from the center of the bottom adjustment hole of the Replacement Drop Leg # TJD-5000-FT to the bottom of the footplate measured about 1-1/2" as you can see in the attached photo.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Replacement Drop Leg for etrailer and Ram Square Direct Weld Jacks - 3K
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 1-3/4 x 1-3/4 Inch Tubing
- etrailer
more information >
Continue Researching
- Q&A: etrailer.com Stabilizer Jacks Mounting Hole Dimensions and Comparison to Atwood Stabilizer
- Shop: Replacement Drop Leg for etrailer and Ram Square Direct Weld Jacks - 3K
- Shop: Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Shop: Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs - Qty 1
- Shop: Fulton Drop-Leg Stabilizer Jack with Mounting Channel - Weld-On - 28" Leg - 13" Bracket -
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Topwind - 29" Lift - 7,000 lbs
- Video: etrailer Trailer Jack - Side Frame Mount Jack - TJDP-5000-FLB Review
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Square Pipe Mount Swivel Jack w/ Footplate - Weld On - Topwind - 15-1/2" Travel - 3,000 lbs
- Shop: Towing Mirrors
- Q&A: Can Landing Gear be Used on Gooseneck Trailer
- Video: Bulldog Trailer Jack - Side Frame Mount Jack - BD195369 Review
- Q&A: Recommended Weld-On Trailer Jack with 15"+ of Travel
- Video: etrailer Trailer Jack TJD-5000-FT Review
- Search Results: stabilizer leg
- Search Results: propane fittings
- Q&A: Recommendation for Weld-On Rear Jacks for 2020 Griffin 7 Ton Dump Trailer
- Q&A: How Much Does 3K Square Direct Weld Jack TJD-5000S Weigh
- Search Results: fulton
- Video: Review of Bulldog Trailer Jack Parts - Square Leg Kit - BD500270
- Video: Bulldog Square Leg Kit with Pin Review
- Search Results: roof vent
- Q&A: Heavy Duty Hitch for my 2003 Chevrolet 2500 HD
- Search Results: hd206
- Q&A: What Are the Weight Ratings for the 2-Tang Clevis for BulletProof Hitches Adjustable Ball Mounts
- Shop: Trailer Hitch
- Search Results: tongue box
- Search Results: heater