Could BOLT Spare Tire Lock part # BL5922986 Fit Underneath Spare Tire Cover
Question:
Are you able to fit a tire cover over this lock in place without damaging the cover?
asked by: Kim
1
Helpful Expert Reply:
The BOLT Spare Tire Lock part # BL5922986 that you referenced can fit under most covers but the best way to determine if it would stick out past the wheel far enough to cause an issue would be to measure from the flange of where a lug nut fits on the wheel out 4.21 inches as that's how far out the lock would stick. In most applications this would not be an issue. Especially if the cover isn't super tight but you'd have to measure to be totally sure.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Q&A: Proper Front to Back Placement of Motorcycle Inside Enclosed Trailer
- Q&A: How Far Forward Should Motorcycle Wheel Chocks Be Installed in a Utility Trailer
- Q&A: How To Determine the Correct Size Lug Nuts For a Trailer
- Q&A: Replacement for Oil Seal POS1501925TB
- Q&A: Possible Quick Connect Recommendation for a 12k Badlands Winch
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can I Determine the psi Rating of a Wheel
- Q&A: Recommended Trailer Tire Size and Load Range for a 14K Tandem Axle Horse Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: The Basics: Firestone Air-Spring Kits
- Article: Rooftop Cargo Carriers
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How Much Does a Boat and Trailer Weigh?