Lippert SolidStep Compatibility with Threshold and Door on 2010 Keystone Montana
Question:
I think you misunderstood metheres already one step made into the trailer floor I want to know when I raise as step up is it going to be in the way can you tell me how wide The Bean Is on your step railI only have eight and a half inches from where you open the door and thats step inside if I knew how big your frame was is it 8 and 1/2 in at 9 in at 10 in the I-beam thats what I need to know
asked by: Butch D
Expert Reply:
We do not carry the Morryde steps so I can't speak to their fit, but we do carry the similar Lippert SolidStep Manual Fold-Down Steps like # LC791575. These have a lip that will go over the threshold you are referencing and will allow the door to close in most cases. I have had one customer with an almost flush threshold that required removing some of the flooring material to allow the fit and door to close, so I do know that customization was required on one trailer but most allow this step to fit and not have any issues with the door.
I've linked the page to all your options because the steps are dependent on threshold height and door frame width. This information is clearly outlined on each product page to assure you get the correct fit. Let me know if you have further questions.
Product Page this Question was Asked From
Lippert SolidStep RV Steps for 29" to 36" Wide Doorways - 4 Steps
- RV Steps
- Towable Camper
- Fold-Down Step
- 24 Inch Wide Step
- 22-1/2 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Aluminum
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Q&A: Replacing Parallex 7345 Converter to One that is Compatible with Lithium Batteries
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Replacement Automotive Lighting
- Article: Trailer Maintenance Schedule
Butch
11/9/2018
I think you misunderstood metheres already one step made into the trailer floor I want to know when I raise as step up is it going to be in the way can you tell me how wide The Bean Is on your step railI only have eight and a half inches from where you open the door and thats step inside if I knew how big your frame was is it 8 and 1/2 in at 9 in at 10 in the I-beam thats what I need to know