Wire Gauge for Extending Wires of Replacement Electric Jack Switch # LC387874
Question:
If the wiring is not long enough what size need run to switch to battery and to motor?
asked by: Tommy
0
Expert Reply:
12 gauge wire would be what you'd want to use to extend the wires of the Replacement Electric Jack Switch with Harness for Lippert Components High Speed Stabilizer Jacks # LC387874.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Lippert
more information >
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Q&A: Wet Shackle Bolts to Reduce Noise from Tandem Axle Travel Trailer Suspension
- Q&A: Trailer GPS Device for Trailer Installation
- Q&A: Battery Life and Charging Time For The Linxup GPS AT3 Tracking Device
- Q&A: Is There a 14 inch Version of Aluminum Viking Series Valhalla Trailer Wheel
- Q&A: What Colors are Trailer Brake Magnets Wires
- Q&A: Why Would New Trailer Brakes Feel Weak After Axle Replace
- Article: How to Choose the Right Trailer Hitch Class
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Tire Sizing
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: Trailer Wiring Diagrams