Troubleshooting One Tail Light Not Working on Trailer
Question:
I installed new wiring harness on my utility trailer. All lights work,hazard,both signal,both brake. My problem is that the left tail light works but the right one doesnt. Its a 4 wire harness. Any ideals.
asked by: Jerry
Expert Reply:
In many cases a bad ground is to blame for one tail light not work, but in order to determine the specific problem you will need to use a circuit tester such as # PTW2979 to test the connector on your tow vehicle after disconnecting it from your trailer. Check the wiring going into your harness from your tail lights to see if those wires are carrying the correct signals, if not then the issue is with the vehicle wiring.
If the signals going to your harness are okay, you'll need to test the signals coming out of the harness, and if they are correct then your issue is likely going to be with the trailer side wiring. You will also want to check both your vehicle and trailer connectors for corrosion, which can be green or white in color. A build-up of corrosion can interfere with the signals getting through the connectors so if it is present you will need to either replace the plug or clean the corrosion and be sure to use Dielectric Grease # LT37534 to help stop any future corrosion.
As I mentioned above, an important issue you will want to take a look at are the ground connections, as they can be the cause of numerous lighting problems. You'll want to make sure your grounds are securely attached to bare metal surfaces free of any paint, dirt or corrosion of any kind. Also check your wiring thoroughly to ensure there are none that are crimped, broken or otherwise damaged. I've added links to a pair of help articles on trailer wiring that you may also find useful.
Products Referenced in This Question
Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube
- Accessories and Parts
- Wiring
- Dielectric Grease
- Loctite
more information >
Product Page this Question was Asked From
Continue Researching
- Q&A: Testing for Proper Voltage on the Brake Output Circuit
- Article: Trailer Wiring Diagrams
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Can Electric Brake Controller Install and Function in Semi Truck with Air Brakes
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: No Power to 12 Volt on 7-Way of 2020 Ram 3500
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: What is Most Common Leaf Spring Length for 3,500 lb Trailer Axle
- Q&A: How to Tell if 2019 Toyota Highlander Has Factory Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting Brake Controller Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)