Installing Replacement Landing Gear on 1993 Avion 35 Gooseneck
Question:
1993 Avion 35 gooseneck weld on landing gear What is involved in removal of old bolt-on gear and welding on the new gear? Is there a source of information for a do-it-your-selfer?
asked by: Jim B
Expert Reply:
Great question. Almost all landing gear includes both bolting and welding. The brackets are welded to the trailer and then the legs have weld stops where the brackets fit and are bolted into place. Most landing gear is fairly similar in the weld stop locations, so new legs don't normally require replacing the brackets however there are some that require cutting off the old brackets and welding new ones in place.
For instance the Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs # LC333964 has the standard weld stop locations at 17-1/2 inches outside to outside and 15-1/2 inches internally. I've attached a couple photos to assist. Most of the time when you replace a lead or follow leg individually, you simply need to match the brand for the threaded pitch to match.
Products Referenced in This Question
Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- Landing Gear
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Replacement Follow Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Does E6 Furrion Thermostat Indicate
- Q&A: Replacement Part Availability for Venture VMC900L Landing Gear
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set
- Q&A: Landing Gear Repair Kit for Venure VMC900L Follow Leg
- Q&A: How to Measure to Pick Out Replacement Landing Gear for a Trailer
- Q&A: Will Blaylock EZ Lock Trailer Coupler Lock fit UFP Square Bodied Coupler
- Q&A: Replacement Motor/Operator Parts for a Ventline Ventadome V2119
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Stability Control for Heavy Duty Vehicles
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Trailer Hitch Drop
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: Trailer Jacks