Can Fulton Bolt-Thru Swivel Jack Handle 600 lbs of Tongue Weight
Question:
Hi, I am looking to replace my A Frame trailer jack with one with a wheel. My jack is much too close to my tailgate. I wanted to see if this would be heavy duty enough to use with a car loaded on, and a tongue weight of about 600 lbs. My concern is that since it is not in the center, it may bend one way. THanks.
asked by: Alex M
Expert Reply:
The Fulton Bolt-Thru Swivel Marine Jack # FXP15L can handle a 600 lb tongue weight without bending; it is rated for 1,500 lbs and that rating is for the tongue weight.
Just be sure your trailer has either a 3" x 3", 3" x 4", or 3" x 5" trailer frame which is the size required for the jack to fit.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 12" Lift - Zinc - 1.5K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 12 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Continue Researching
- Q&A: Do Trailer Jacks with Two Wheels Make it Easier to Maneuver a Jack on Concrete
- Article: Trailer Tire Sizing
- Q&A: Kickstand Jack Recommendation For A Malone Microsport Trailer
- Q&A: Replacement Parts for Shelby 5854A Trailer Jack
- Q&A: Is the Mounting Pattern for the Fulton Jacks FXP15 and FXP10 the Same
- Q&A: How To Determine the Correct Boat Trailer Jack Weight Capacity
- Article: Trailer Jacks
- Q&A: Dual Propane LP Tank Setup 100 Lb for RV or Travel Trailer
- Q&A: What is the Standard Bolt Pattern for Pintle Hooks
- Article: How to Install E-Track in 3 Easy Steps
- Article: What Exactly is Tongue Weight?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Measuring a Trailer Tire