Replacement Landing Gear with 16 Inch Bracket Stop Spacing on a 1994 Jayco Eagle
Question:
Hello! We have atwood landing gear that is 16 inches from bottom to bottom of mounting brackets. Is there anything that will replace them? Our current ones are stripped.
asked by: Trish
Expert Reply:
The standard bracket stop spacing on landing gear legs is 15-1/2 inches between the top and bottom stops and 17-1/2 inches from the top of the upper stop to the bottom of the lower stop. If you have a 16 inch measurement then the only way to get something to work would be to have a professional welder relocate the brackets on your trailer so the spacing matches up. That would then allow you to use Bulldog Landing gear # BD500162 or a similar set.
Product Page this Question was Asked From
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Continue Researching
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Water Heater To Replace Atwood Gc6aa/10E
- Q&A: Battery Box that Can Fit Trailer Frame
- Q&A: Is Dometic 6-Gallon RV Water Heater DMC74FR Best Option For Tanked Water Heater
- Q&A: Do Lippert Carpet Protectors for RVs with Slide Outs # LC134993 Permanently Install
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Hopkins Electronic LED Smart Level Mounting Instructions For A Motorhome
- Article: Best Bike Racks for Electric Bikes
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Does Solar Panel Type Really Matter?
- Article: Best Landing Gear
- Article: What To Look For When Buying Ratchet Straps